04-06-2014, 07:15 PM
I personally use UNetbootin in Linux Lite 1.0.8 (installed via Synaptic) and it works well. Not 100% of the time, maybe 80-90%.
After installing UNetbootin there was a bug where it would keep asking for the administrator password in a loop. It wouldn't accept any value. Here's the fix I used:
Open a terminal
Type: gksu-properties
When the little GUI pops up make sure "sudo" is selected, not "su," as the authentication code.
On the Windows side I used these utilities in the past:
Your Universal Multiboot Installer (YUMI)
Universal USB Installer
The two above come from Pen Drive Linux http://www.pendrivelinux.com/. This site has lots of great information.
Good Luck,
Scott
After installing UNetbootin there was a bug where it would keep asking for the administrator password in a loop. It wouldn't accept any value. Here's the fix I used:
Open a terminal
Type: gksu-properties
When the little GUI pops up make sure "sudo" is selected, not "su," as the authentication code.
On the Windows side I used these utilities in the past:
Your Universal Multiboot Installer (YUMI)
Universal USB Installer
The two above come from Pen Drive Linux http://www.pendrivelinux.com/. This site has lots of great information.
Good Luck,
Scott
![[Image: q7j1yAl.png]](http://i.imgur.com/q7j1yAl.png)