01-09-2015, 11:36 PM
He has to put anything he imagines on the paper and when the clients approve, he starts working.
Machines help a lot. He uses machines to get to the level where he can start using hand tools. Otherwise it would take him a lot of time. Especially in the case where he has to drill the hole through the stone 10-15cm wide. I've tried doing what my brother does - I took the hammer and a chiselt. It was tricky to guess the amount of strength to use. I was afraid not to make a mistake and damage my brother's work. When he does it it looks so easy.
CNC's are for mass production. This is all about the skills.
Machines help a lot. He uses machines to get to the level where he can start using hand tools. Otherwise it would take him a lot of time. Especially in the case where he has to drill the hole through the stone 10-15cm wide. I've tried doing what my brother does - I took the hammer and a chiselt. It was tricky to guess the amount of strength to use. I was afraid not to make a mistake and damage my brother's work. When he does it it looks so easy.
CNC's are for mass production. This is all about the skills.