Drivers installed but not "loaded"

[Jim0000]

Post back with

Code:

sudo lshw -C network

so we can see if the installation has done what we wanted.

Clicking on the Network icon (usually in the bottom right area) should give you a list of Wifi Networks that the adaptor can see.  You will need to set up the system so that it can join your network.

sudo lshw -C network
[sudo] password for jim:
  *-network               
      description: Ethernet interface
      product: NetLink BCM5906M Fast Ethernet PCI Express
      vendor: Broadcom Inc. and subsidiaries
      physical id: 0
      bus info: pci@0000:06:00.0
      logical name: enp6s0
      version: 02
      serial: b8:ac:6f:a1:fa:80
      size: 100Mbit/s
      capacity: 100Mbit/s
      width: 64 bits
      clock: 33MHz
      capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd autonegotiation
      configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=5.15.0-46-generic duplex=full firmware=sb v3.04 ip=192.168.1.101 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s
      resources: irq:31 memory:febf0000-febfffff
  *-network
      description: Wireless interface
      physical id: 3
      bus info: usb@2:4
      logical name: wlx90de8026e158
      serial: 90:de:80:26:e1:58
      capabilities: ethernet physical wireless
      configuration: broadcast=yes driver=rtl88x2bu driverversion=v5.13.1-20-gbd7c7eb9d.20210702_ firmware=30.20 link=yes multicast=yes wireless=unassociated