Drivers installed but not "loaded"

[Jim0000]

Post back with

Code:

sudo lshw -C network

so we can see if the installation has done what we wanted.

Clicking on the Network icon (usually in the bottom right area) should give you a list of Wifi Networks that the adaptor can see.  You will need to set up the system so that it can join your network.

Code:

[sudo lshw -C network
[sudo] password for jim:
  *-network                 
       description: Ethernet interface
       product: NetLink BCM5906M Fast Ethernet PCI Express
       vendor: Broadcom Inc. and subsidiaries
       physical id: 0
       bus info: pci@0000:06:00.0
       logical name: enp6s0
       version: 02
       serial: b8:ac:6f:a1:fa:80
       size: 100Mbit/s
       capacity: 100Mbit/s
       width: 64 bits
       clock: 33MHz
       capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=5.15.0-46-generic duplex=full firmware=sb v3.04 ip=192.168.1.101 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s
       resources: irq:31 memory:febf0000-febfffff
  *-network
       description: Wireless interface
       physical id: 3
       bus info: usb@2:4
       logical name: wlx90de8026e158
       serial: 90:de:80:26:e1:58
       capabilities: ethernet physical wireless
       configuration: broadcast=yes driver=rtl88x2bu driverversion=v5.13.1-20-gbd7c7eb9d.20210702_ firmware=30.20 link=yes multicast=yes wireless=unassociated

/code]