ls /dev

[Moltke]

As you can see I ran the code , I then inserted a USB stick and used up arrow on keyboard to reuse the same code and run it again, thus allowing for a comparison of before and after adding the USB stick.
It produced 2 new results the /dev/sdb and the /dev/sdb1 rather than the 1 new result I was expecting, why is this ?

[member=411]bitsnpcs[/member]  I'm not sure what you're trying to do, but it seems that you want to ls into a usb stick? if so, then I think the correct path would be run/media/bitsnpcs, like so:

Code:

$ ls /run/media/bitsnpcs

and then your usb stick should appear in the list just like mine - MOK - does as you can see in the image bellow. 



You might want to read here: http://www.tldp.org/LDP/Linux-Filesystem...l/dev.html

Hope this helps!