installed 2.0 and will not reboot

[Scott(0)]

Hi Hardball45,

is this a normal thing on reboot

It's not normal but it does happen to me occasionally. When it happens I just do a force power down by pressing and holding the power key until the machine turns off. Fortunately, it has never caused a problem. The machine boots normally and powers down successfully on the next on/off cycle.

should i have selected continue testing and then shut down the normal way?

This is the way I do it. And I make sure to pick shutdown, not reboot after a fresh installation. I can't say if this method works any better but it may because I experience the problem so seldom.