04-11-2018, 04:10 PM
Hi all
I'm trying to revive a Fujitsu Amilo 1705 with an 120gb SSD and installing 'Lite' 3.6.
So far, I can get Lite to display the initial pages in 'safe' mode but it will not load onto the SSD.
From (my) memory it displays a panel with various tabs for internet, installing software et al. I couldn't get it to do anything else, so I figured the only way forward seemed to go for the desktop option to install on a hard drive - which didn't work as it couldn't see the SSD.
SSD has been formatted NTFS and given a E: label since I had to do this on my main W10 (urghh!) and I'm wary of confusing and crashing it so rather than give it an c: - I settled on E;. It is the only drive on the Fujitsu.
I did use MBR as it seemed in sync with an old computer.
If it is a NTFS problem I'm not sure what to change it too or how to. I'm using Western digital data lifeguard diagnostics.
Any thoughts?
I'm trying to revive a Fujitsu Amilo 1705 with an 120gb SSD and installing 'Lite' 3.6.
So far, I can get Lite to display the initial pages in 'safe' mode but it will not load onto the SSD.
From (my) memory it displays a panel with various tabs for internet, installing software et al. I couldn't get it to do anything else, so I figured the only way forward seemed to go for the desktop option to install on a hard drive - which didn't work as it couldn't see the SSD.
SSD has been formatted NTFS and given a E: label since I had to do this on my main W10 (urghh!) and I'm wary of confusing and crashing it so rather than give it an c: - I settled on E;. It is the only drive on the Fujitsu.
I did use MBR as it seemed in sync with an old computer.
If it is a NTFS problem I'm not sure what to change it too or how to. I'm using Western digital data lifeguard diagnostics.
Any thoughts?