Hi,
I have just run the installer again to check and checked the instructions
Accept the defaults*, until the last screen:
Re-start or Plugin, select ignore.
Then select install method GUI, and a GUI opens.
You need a temporary connection via USB.
Then choose Wireless/802.11(3rd option down), step through the screens adding it to your WiFi network.
On the last screen, make a note of the hp-setup & ip.address.
Disconnect the USB cable, open terminal and enter command.
[size=1em]![[Image: GKZgFW2.png]](http://i.imgur.com/GKZgFW2.png)
[/size]
I have just run the installer again to check and checked the instructions
Accept the defaults*, until the last screen:
Re-start or Plugin, select ignore.
Then select install method GUI, and a GUI opens.
You need a temporary connection via USB.
Then choose Wireless/802.11(3rd option down), step through the screens adding it to your WiFi network.
On the last screen, make a note of the hp-setup & ip.address.
Disconnect the USB cable, open terminal and enter command.
[size=1em]
[/size]
Upgrades WIP 2.6 to 2.8 - (6 X 2.6 to 2.8 completed on: 20/02/16 All O.K )
Linux Lite 3.0 Humming on a ASRock N3070 Mobo ~ btrfs RAID 10 Install on 4 Disks
Computers Early days:
ZX Spectrum(1982) , HP-150 MS-DOS(1983) , Amstrad CPC464(1984) , BBC Micro B+64(1985) , My First PC HP-Vectra(1987)
Linux Lite 3.0 Humming on a ASRock N3070 Mobo ~ btrfs RAID 10 Install on 4 Disks
Computers Early days:
ZX Spectrum(1982) , HP-150 MS-DOS(1983) , Amstrad CPC464(1984) , BBC Micro B+64(1985) , My First PC HP-Vectra(1987)