12-16-2015, 12:39 AM
Hi,
When you run the installer you need the printer to be connected with USB cable initially.
Follow instructions, and when the installers finished,
It should say:
"Now Remove the USB Cable" and then run HP-Setup ip.address in a terminal
The ip.address will be shown on the last screen.
Yes, that link is dead by the look's of things
All I can say is it worked for me and was done in a few minutes
WiFi is switched on on your printer..??
When you run the installer you need the printer to be connected with USB cable initially.
Follow instructions, and when the installers finished,
It should say:
"Now Remove the USB Cable" and then run HP-Setup ip.address in a terminal
The ip.address will be shown on the last screen.
Yes, that link is dead by the look's of things
All I can say is it worked for me and was done in a few minutes
WiFi is switched on on your printer..??
Upgrades WIP 2.6 to 2.8 - (6 X 2.6 to 2.8 completed on: 20/02/16 All O.K )
Linux Lite 3.0 Humming on a ASRock N3070 Mobo ~ btrfs RAID 10 Install on 4 Disks
Computers Early days:
ZX Spectrum(1982) , HP-150 MS-DOS(1983) , Amstrad CPC464(1984) , BBC Micro B+64(1985) , My First PC HP-Vectra(1987)
Linux Lite 3.0 Humming on a ASRock N3070 Mobo ~ btrfs RAID 10 Install on 4 Disks
Computers Early days:
ZX Spectrum(1982) , HP-150 MS-DOS(1983) , Amstrad CPC464(1984) , BBC Micro B+64(1985) , My First PC HP-Vectra(1987)