09-23-2015, 03:22 PM
"Mark All Upgrades" did not select any packages.
I think the last package to get installed was Plastic SCM, but I've done a few updates in the past without issue.
This was the first time it hung on me, and it was strange it did it on both systems, though they are setup identically (save for one being 32bit and the other being 64bit).
I ended up just canceling, I think I'll start updating from the commandline so I can see where it gets stuck in the future.
Too bad there wasn't a way to show that through the GUI, currently seems you can only view the log at the end of the process.
I think the last package to get installed was Plastic SCM, but I've done a few updates in the past without issue.
This was the first time it hung on me, and it was strange it did it on both systems, though they are setup identically (save for one being 32bit and the other being 64bit).
I ended up just canceling, I think I'll start updating from the commandline so I can see where it gets stuck in the future.
Too bad there wasn't a way to show that through the GUI, currently seems you can only view the log at the end of the process.