04-07-2015, 06:27 PM
(This post was last modified: 04-07-2015, 09:00 PM by gold_finger.)
the md5 hash matches on both the LL 2.2 and 2.4 iso...no problems there
yes..either way...i can perform an install before i try to log out of a live session and
then it wants to restart...i click on it and the same...it hangs...i reset
the pc and go to desktop...try to logoff...hangs...freezes...error comes later
i changed the bus id numbers to 0...i thought it was maybe a hardware id number(like a mac address)...specific to each board...if its not and its integral to solving this issue, let me know and i'll post em
I tried uefi and legacy and legacy is the only one that works on boot
I tried the ctrl..alt method and the screen went totally black...locked up to a blinking cursor in the corner
i like lubuntu but its just not the same when you use LL...it just doesnt have the right amount of software that LL does. Xubuntu is fine but its a little slower loading that Lubuntu and LL. Same RAM usage but still slower loading I noticed.
Quote:P.s.
Do you have the shutdown problem on both the live USB and the installation you performed?
yes..either way...i can perform an install before i try to log out of a live session and
then it wants to restart...i click on it and the same...it hangs...i reset
the pc and go to desktop...try to logoff...hangs...freezes...error comes later
Quote:inxi -Fxz
Code:
GLX Renderer: Gallium 0.4 on AMD KABINI GLX Version: 3.0 Mesa 10.1.3 Direct Rendering: Yes
Audio: Card-1: Advanced Micro Devices [AMD] FCH Azalia Controller driver: snd_hda_intel bus-ID: 0
Card-2: Advanced Micro Devices [AMD/ATI] Device 9840 driver: snd_hda_intel bus-ID: 0
Sound: Advanced Linux Sound Architecture ver: k3.13.0-24-generic
Network: Card: Realtek RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller
driver: r8169 ver: 2.3LK-NAPI port: d000 bus-ID: 0
IF: eth0 state: up speed: 100 Mbps duplex: full mac: <filter>
Drives: HDD Total Size: 151.3GB (-) 1: id: /dev/sda model: KINGSTON size: 120.0GB temp: 36C
2: USB id: /dev/sdb model: Transcend_32GB size: 31.2GB temp: 0C
Partition: ID: / size: 1.7G used: 37M (3%) fs: overlayfs
RAID: No RAID devices detected - /proc/mdstat and md_mod kernel raid module present
Sensors: System Temperatures: cpu: 20.6C mobo: N/A gpu: 20.0
Fan Speeds (in rpm): cpu: N/A
Info: Processes: 193 Uptime: 1 min Memory: 350.7/3321.1MB Runlevel: 2 Gcc sys: 4.8.2
Client: Shell (bash 4.3.11) inxi: 1.9.17i changed the bus id numbers to 0...i thought it was maybe a hardware id number(like a mac address)...specific to each board...if its not and its integral to solving this issue, let me know and i'll post em
I tried uefi and legacy and legacy is the only one that works on boot
I tried the ctrl..alt method and the screen went totally black...locked up to a blinking cursor in the corner
i like lubuntu but its just not the same when you use LL...it just doesnt have the right amount of software that LL does. Xubuntu is fine but its a little slower loading that Lubuntu and LL. Same RAM usage but still slower loading I noticed.