11-13-2020, 04:30 PM
(This post was last modified: 10-12-2021, 05:29 PM by firenice03.)
Installed one of my favorite docks...wbar... after initial installation of 5.2.
Setup was more or less fine, but now wen I click on the icon wbar provides to
add or edit applications, the screen comes up but it is not responsive for up to
30 seconds. Then it becomes active and can be used fine.
I know this application is old...as far as I know it hasn't been updated
since 2012 or 2013, but I also have it on my Debian Bullseye and Fedora 33 partitions
and there are no problems with it there.
wbar-config is the problem.
In addition I installed Rox-filer oday and found similar lag problems.
The common thread is that they both use GTK2-0. Other GTK3-0
software doesn't exhibit this problem.
Has anyone experienced this or does anyone have a possible solution ??
Thanks
Setup was more or less fine, but now wen I click on the icon wbar provides to
add or edit applications, the screen comes up but it is not responsive for up to
30 seconds. Then it becomes active and can be used fine.
I know this application is old...as far as I know it hasn't been updated
since 2012 or 2013, but I also have it on my Debian Bullseye and Fedora 33 partitions
and there are no problems with it there.
wbar-config is the problem.
In addition I installed Rox-filer oday and found similar lag problems.
The common thread is that they both use GTK2-0. Other GTK3-0
software doesn't exhibit this problem.
Has anyone experienced this or does anyone have a possible solution ??
Thanks