LL 6.6 runs OK after clean install, but crashes after about 24-hours - Printable Version +- Linux Lite Forums (https://www.freecinema2022.gq/forums) +-- Forum: Software - Support (https://www.freecinema2022.gq/forums/forumdisplay.php?fid=5) +--- Forum: Installing Linux Lite (https://www.freecinema2022.gq/forums/forumdisplay.php?fid=17) +--- Thread: LL 6.6 runs OK after clean install, but crashes after about 24-hours (/showthread.php?tid=8972) |
LL 6.6 runs OK after clean install, but crashes after about 24-hours - alloydog - 11-10-2023 I got *new* laptop and did a clean installation of Linux Lite 6.6. Ran through the updates and so on. Everything ran OK, even after a few reboots the same evening. Then the next day, I started the laptop and after login, the desktop launched OK, then suddenly the screen scrambled (multi-coloured horizontal lines), then blank. After a few seconds, the laptop rebooted. Again, logged in OK, desktop started OK, but this time it just went blank. The next day (yesterday, relative to this post) I did a new clean install. That evening, all was well. Home from work now, booted laptop and get the same crash sequence. The only thing I can think, so far, is that during installation, I checked install third-party drivers, which required me to give a password for secure boot. It said that I would be asked for this password on next boot up. However, on both occassions, I have not been asked for the secure boot password. I am now running this from the USB stick. The laptop is a Lenovo ideapad 330 with AMD A6 processor and STONEY graphics. How can I start looking for problem? |